Emtech-electronics BLU-CC Manual de usuario descargar pdf (Pagina 3)

There is a green LED located on the backside of the BLU-CC. If you have

installed the power correctly on CC1, the green LED will light up. The

presence of this LED does not replace the required CAT5 568A/B

testing prior to connecting the cables.

Using the BLU-CC2 with older BLU-CIF systems

When setting up the BLU-CC2 for a system that uses an older version of the

BLU-CIF and the old BSS template, move the slide switch to Mode 2. The

wiring on the BLU-CC2 side remains the same as Mode 1, but the following

wiring changes need to be made on the BLU-CIF board

Mic 3/Aux Output Pin outs (3-Pin Euro Block)

Top = Shield

Middle = +

Bottom = -

Top Mid Bttm

Shield + -

1 2 3

Sin comentarios

Emtech-electronics BLU-CC Manual de usuario Pagina 3